News

Home > News > Content
Agricultural Tires Correct Maintenance Steering System
Jun 19, 2017

The length of service life of Agricultural Agricultural Tires Agricultural Tires for the use of quality, operating efficiency and safety have a crucial relationship, we must use the scientific maintenance of Agricultural Tires to extend its service life.

First of all, to maintain the appropriate tire pressure, and according to the vehicle under the environmental conditions of appropriate adjustments, tire pressure is too low or too high, the risk is great, not only shorten tire life, reduce operating efficiency, and may even cause puncture accident.

The correct driving operation, so that "six slow", that is slow start, slow to slow, slow braking, slow downhill, slow and slow road slow travel, try to avoid high-speed sharp turns and emergency braking. Keep the agricultural vehicle load balanced, does not appear serious overload behavior.

Correct maintenance of the steering system, to maintain the correct value of the beam before the tire to prevent early wear.

Timely maintenance and repair, in the car before and after the car carefully check whether the tire scratches, deformation, loose, stained with oil, etc., in time to eliminate hidden dangers, if necessary, adjust maintenance and repair.

When the Agricultural Tires are dismantled, they should be carried out on a clean ground without a gap or sharp angle. When installing, do not bring the sediment into the direction of the pattern.

Try to avoid direct exposure to high temperature sunshine, do not contaminate the oil on the oil, acid, alkali, so as not to corrosion. Long-term parking does not work as much as possible so that the tire does not bear a large load, the vehicle should be the top, so that the tire does not bear the pressure, but not deflated.

Agricultural vehicles in the driving, it is inevitable that rubber Agricultural Tires discouraged, nails or puncture, etc., need to remove the damaged wheels as soon as possible to repair, or spare tire replacement. How to do it faster and better?

First, keep in mind the wheel tightening bolts. The right side of the wheel nut is made of right-hand thread (orthodontic), the left side of the wheel nut made of left-hand thread (anti-teeth). Therefore, loosen the left side of the wheel nut should be clockwise force, tighten the time should be counterclockwise force.

Second, take the diagonal, cross, sub-3 to 4 times the method of twisting the nut, to prevent the deformation of the wheel and the force concentrated in the individual wheel bolts.

Third, the demolition, the first with the sleeve wrench unscrew the wheel nut, temporarily removed, and then jack up the axle, until the tire slightly left the ground, and then loosen the nut, lift the wheel.

Fourth, the installation of the thread coated with lithium or calcium-based grease, in order to reduce the possibility of slider. Lift the wheel when you want to align the bolt hole, so as not to break the bolt thread, first hand tighten, and then use a special wrench to the wheel does not loose, remove the jack, so that the wheels down to the ground.

Fifth, the installation of tire assembly, the tire should be on the front of the brake drum ramps.

Six, for twins and loaded rear wheels, should note the following:

① If the two Agricultural Tires are not the same degree of wear, should be larger diameter, lighter wear one mounted on the outside, to meet the needs of arched road driving.

② If only the outer Agricultural Tires are replaced, tighten the inner nuts of the inner wheels and then install the outer wheels.

③ two Agricultural Tires at the same time to replace, use jack jack twice up the axle, were installed inside and outside the tire.

④ two wheels on the brake shoe clearance check hole should be staggered.

⑤ inside and outside the two rounds of the valve should be symmetrical arrangement, in order to facilitate the inspection and adjustment of tire pressure.